Quick reference card
Print this page and the next on one sheet. Every line is in the chapters that follow, and the keys are read from the app's own list.
Place
Edit
Run the live simulation
Simulate and analyse
View and find
Files and tabs
Mouse
Typing numbers
| Type | Means |
|---|---|
4k7, 4.7k | 4 700 |
100n | 100 × 10⁻⁹ |
2u2, 2.2µ | 2.2 × 10⁻⁶ |
10m | 0.01 (milli) |
1Meg, 1M | 1 000 000 in fields |
1R5 | 1.5 |
10 kΩ, 5V | units are ignored |
| Up / Down | next value (Shift: finer, Ctrl: a decade) |
| PageUp / PageDown | next standard value (E12, E6, rails) |
On the command line and in netlists 1M is milli. Write 1Meg everywhere.
Files
| File | Holds |
|---|---|
.bsc | A circuit, with probes and settings |
.bspart | A part from a datasheet |
.bssym | A schematic symbol |
.cir | An exported ngspice netlist |
Signs on screen
| You see | Means |
|---|---|
| running / paused (status bar) | Live simulation on or paused. Ctrl+R. |
| idle | Empty sheet: nothing to run |
| Red Halted | Stopped on an error. Click it. |
| Live MNA · WASM | Fast live engine |
| Live MNA · JS | Slower fallback, same results |
| ngspice 47 ready | Vendor models can run |
| Red badge | An error: Alt+6 |
| Amber badge | Warnings only |
| example on a tab | Not your file: Save as |
Voltage colours
New look (the default on a fresh install): one voltage scale from 1 mV to 1 kV, pale yellow to green at 48 V and blue past 50 V, red to purple for negative, and current dots that grow with the current. Classic look: positive green, negative red, zero grey, current dots yellow, and Ctrl+Shift+K switches to orange and blue. picks the look.
MCU code
pin LED out, pin BTN in pullup, bus I i2c SDA SCL. loop, every 1ms, when BTN falls, wait 10ms. pin LO complement HI dead 200ns. I²C needs pull-ups. Programming the MCU.
Which result to trust
Live shows. Simulate (F5) measures, with vendor models in ngspice or PSpice for TI.
Codes you meet most
| Code | Fix |
|---|---|
E_NO_GROUND | Place a ground symbol on the 0 V net. |
E_FLOATING_NET | Add a resistor from the net to ground, or connect the capacitor or gate that isolates it. |
E_VSRC_LOOP | Add a series resistor, or give the inductor a small dcr. |
E_NEWTON | Check that part's values and connections, add a series resistor, or lower the maximum timestep. |
E_TIMESTEP | Add a gate resistor, slow source edges, raise the maximum step or shorten the run. |
E_PARAM | Set the value inside the range given in the message. |
W_NO_MODEL | Double-click the part and choose a model, or, for a blank Subcircuit / IC or a generic chip, choose Edit subcircuit and draw the inside. |
E_NGSPICE_MISSING | Reinstall, or set BSPICE_NGSPICE. |
When stuck
Troubleshooting by symptom. Diagnostics and what they mean. Task index.